This is a 3-point felling dawgs/bucking spikes for Husqvarna T540i xp and T542i xp. Since the center dawg is longer, it will act as the pivot point. This dawg is smaller/shorter than others on the market. A shorter dawg will help utilize available bar length, reduce leverage on the saw's mounts, are less likely to bend, and won't cause your chain to be overly aggressive. In the effort to keep prices low, these are neither coated nor painted. Made in the USA from AR500 alloy steel. This felling/bucking dawg has a lifetime warranty.
Just a single dawgs is included, which mounts on the saw case, and not the clutch cover. Mounting hardware is not included.
NOTE: The site will automatically calculate Priority Mail Flat Rate for shipping during checkout. When you only order felling dogs (and no other products) we will send them to you via USPS Ground Advantage when doing so will result in significant savings in the cost of shipping (within the U.S. only - international orders will be sent Priority Mail). We will refund you the difference when that occurs.
I've just received one of these via Sean from builtbysean in Tasmania, Australia and can attest that it is of the usual high EPS quality and fits my brand spankin' T542iXP perfectly and performs as well as expected.
The reduced centre dog length is perfect as mentioned because it doesn't eat into the already short bar length; my thoughts also ran to not straining the plastic mount points on the saw body.
(Picture taken with stupidly wide 16" bar from my 550XP just to see; it would be good for a few cuts but for longer use I'd want .043" or .050" on it.)